We are using the docker image from linuxserver, the configuration proposed in this tutorial is based on suggestions from linuxserver/calibre-web on how to run the service using the docker command-line. You need to confirm your intent to install calibre-web on another popup window.īefore the service will be started you need to configure it properly to provide information about where your Calibre book library (or multiple libraries) is located, configure the IP where the service will be available, etc.Select latest unless you have good reason to use an older version. The popup window for version selection should be displayed.Search for the calibre-web docker image in the Create tab of the Container Station.Install service from Docker Container via Container Station We will be using dockerized version of janeczku/calibre-web Install service from Docker Container via Container Station.The installation described here was done on TS-251+ (Celeron J1900 4 Cores) but should be applicable to a wide variety of other QNAP NAS models.Ĭaution: This is a simple setup assuming that service will be used only within the LAN by the trusted users and therefore access management, other networking, and security matters are not in the scope of this tutorial. This tutorial shows how to install calibre-web on QNAP-NAS. Calibre-Web is a web app providing a clean interface for browsing, reading, and downloading eBooks using a Calibre database.
0 kommentar(er)
